Please help my Alpha mesh is very angree! And I can't figure out why. :(
BlueIzumi:
Never mind I got lucky and my friend who doesn't have alot of DL's came on she told me it was in everyday. AND! My everyday worked so fast it took me 25 minutes to go through it istead of 5 hours! I FEEL LUCKY TODAY! :P XD
!@_~!
BlueIzumi:
Okay here's the end result with all the peices sticking out finished. ^_^ ON MY BIRTHDAY SIM YEAY! :P Anyways tell me what you think I'm so happy thank you so much for all your help... I kinda redid the whoel bust area and then I did some major work on her rear. :) Thank you so much again for setting this up you're name is all over my mesh for credit I hope you don't mind. :) And I you're okay if this is okay I have another question for you it's about my hair. I hope you don't mind me asking about that you've just been so freaking awsome for helping me with this. And I changed it to pink because on my meshes it means alpha editable but not see though. :P
Thanks again.
!@_~!
BlooM:
Its looking good :thumbup:
Wats with the hair then?
Its editible but doesn't give you transparancy?
I do not know how many layers are involved but you can enable transparancy in the TXMT's from the hair package(similar as outfits)
stdMatAlphaBlendMode is set to blend when you want the transparancy but stdMatAlphaTestEnabled should be set to 0 then.
If there are to many layers involved you might end up with bleeding through wich also was the problem with your outfit at first.
You sometimes can fix it with editing the opacity settings from the meshgroups.
BlueIzumi:
hey sorry it's taken so long for me to answer my computer hasn't been 100% and it's still not but it's doing a hell of alot better then it was ^_^. *fingers crossed* ANYWAYS! I have a picture of the hair if you'll still have a look? And if I'm allowed I will upload the files too? The problem is the overlay makes the layers see through with the alpha editing it's so anoying and obvious. :(
AND ALSO! :) I am including a picture of the finished mesh with credit to you on it. I hope I've given enough credit please tell me if I have not :).
!@_~!
BlooM:
the hair settings should be set to blend in the TXMT's(not alphatest enabled)
Then you have to fix the opacity on the layers(you can do this in Milkshape)
The 1st layer(prolly a inside layer) positioned the closest to the head must have the lowest opacity(starting with 3 while the body is -1)
then comes the outside layer wich is set to 5
Every layer that comes on top of those have to have a higher setting, the next layer needs 7 and 9 and so on.
You do not have to credit me Hun, it 99% your work here!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page