Hey guys!
I posed this question on MTS2 several days ago, but have yet to get a response, so I'm hoping someone here can help me.
I'm attempting to make an end table with an additional slot on the bottom shelf. I have the slot, but when I went to change the translation value to move it up off the floor, I noticed that the Z value was missing. I thought I might have done something wrong, so I took a look at a couple other items with added slots, and lo and behold, they don't have a spot to change Z values either.
I could be misunderstanding the instructions (which is quite likely). Where do I go in CRES to change the Z translation value?
Thanks so much for any help you can offer!
:rabbit: Avery