Adding Pregbot in Milkshape
BlooM:
Im not so good in these things, how they programmed and stuff but i noticed on the 34Afullbodyalphamesh that a few faces from the fatmorph overuled(dont know how to say diffrent) the pregmorph.
So it seems when fat and pregnant the 2 morph's are active at the same time, maybe this will cause problems...
edit, me bad
Those probs i described above will never happen with a maxis mesh as all groups will use the same textures.
They maybe clip but it will never show.
I forgot its a alpha mesh wich had the nude body underneath it, and that one keeps clipping with the alpha
when both fat and preg state are active.
themysticalone:
Seems to work well for me. I built a magnet that pretty closely matches the maxis pregnancy bump and then used it to add on to the afBodyTweedJacket mesh (as a default). Now I can use it as a base in mesh tool when I'm conveting to the various cup/hip combinations.
Thanks BlooM!
BlooM:
Good Job!
should try it with fat and preg both also , thats were i got some clipping probs.
but watever i tried, couldn't solve it.
themysticalone:
I did, after reading one of your above posts. I couldn't see any clipping anywhere, but I'll keep an eye out.
BlooM:
Quote from: themysticalone;788740
I did, after reading one of your above posts. I couldn't see any clipping anywhere, but I'll keep an eye out.
And you made both fat and pregmorph yourself?
I just could not get it figured out, it looked like the fat and pregmorph were linked to eachother somehow cos parts that were normally fat dissapeared when pregnant while other parts stayed fat.
Navigation
[0] Message Index
[#] Next page
[*] Previous page